Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Auto Bandswitching Module for ICOM IC-2KL, IC-4kl and PW1 Amplifiers
Andy,Please answer the following:1) I assume you are talking about a TenTec Model 420?2) Do you have the 15 pin molex (remote) connector hooked up with any wires?Ed W2PH1 -
Re: Auto Bandswitching Module for ICOM IC-2KL, IC-4kl and PW1 Amplifiers
Andy,Here is my suggestion. Order the FTDI cable C232HM-EDHSL-0 which you can get from digikey. . You will want to put Molex pins on enough wires for ground and each band that fit into the 15 pin con…1 -
Re: Auto Bandswitching Module for ICOM IC-2KL, IC-4kl and PW1 Amplifiers
Andy, just get the molex pin removal tool and crimp new pins onto the FTDI cable ends and insert them into the old molex housing. I would expect the mlex pins are still available...1 -
Re: Yaesu Quadra
Digikey sells it for far less :-)1 -
Re: Furnace Blower RFI - Suggestions?
I had the same problem.. Popped open the inside unit and installed 10 split ferrites Mix 31 on all wiring harnesses that I could get to..... including wires to thermostat (great antenna). Problem is …1
